1.08.2013

DIY: Bracelet Caddy

So can we just talk about how hard it is to store jewelry? I mean seriously... any kind of jewelry... it is just hard to find a safe place to put it so it doesn't get ruined or tangled or lost.

Throughout the years I've found ways to store my necklaces and earrings but bracelets... those little buggers just seem to lay around. Until now....


I finally found a way to safely and functionally store my bracelets! What do you think? I kept it simple finishes wise just because it fit my bedroom decor better that way but the possibilities are endless with it! Bare wood... ooh there is soooo much you could do!

Supplies
MDF--cut down to 3" W x 15" L
1-1/2" Wood dowel--cut to 9" Lc
Wood glue
Drill bit that will allow you to countersink your screw
Drill bit
3 Wood screws


Instructions
Begin by measuring where each dowel will be attached.


You will want to measure in from the left 4" for the first dowel. Measure in 3-1/2" to the second dowel, and another 3-1/2" for the third dowel. This will leave 4" to the far edge. Next measure 1-1/2" from the top edge in so the dowels will be placed in the center of the MDF width wise.

Once you have the placement for each dowel measured out, use the countersink drill bit to drill out enough of the MDF for the screw to not stick out beyond the MDF. You want the MDF to be able to sit flat.


Next pre drill a hole in the MDF and in the dowel so that you won't have any puckering or movement when you go to attach everything.


Okay, time to attach the dowels! Apply a little wood glue to the end of the dowel (where it is going to attach to the MDF).


Drill up through the bottom of the MDF through the wood and into the dowel and ta-da! Attached!


Now you can spice up the wood any way you would like! I wanted to keep it simple so I actually didn't do anything to the wood. I was imagining though a bright neon paint around the edges of the wood. Or using scrapbook paper around the edges or around the dowels. Ooooh the possibilities!!


Finally... use it! Layer those gorgeous bracelets up and admire how marvelous it looks and how fabulously functional it is!

14 comments:

  1. very clever!! I am going to make one x

    ReplyDelete
  2. Nice work jss! That's my LOVE language...build me somethin!

    ReplyDelete
  3. This is such a good idea! I need to do something with my bracelets - they are all over the place!

    ReplyDelete
  4. that's a great idea! if my cats wouldn't think the beads on my bracelets were for chewing, i'd totally do it, too.

    ReplyDelete
  5. Great idea! I am pinning now www.pinterest.com/hbrummett. Thanks for linking up to our pin party!

    ReplyDelete
  6. Great idea! Pinning this to my jewelry display board.

    ReplyDelete
  7. What a great idea!! I need storage solutions for my necklaces. How do you keep those organized? Thanks for sharing this at the weekly creative :)

    Shannon @ Sewing Barefoot

    ReplyDelete
  8. I just made some bracelets and I am trying to figure out a better way to store them. This is a great idea.

    ReplyDelete
  9. Cute idea!! Thanks for sharing!

    Found you at The Weekly Creative and I am your newest follower!

    Check me out at www.MyHoneyBunch.CO

    Thanks,
    Darlene
    www.stork1.blogspot.com

    ReplyDelete
  10. What a great idea. This would be ideal for my daughter's room.

    ReplyDelete
  11. very cool idea, and pretty cheapn to make too, thanks for sharing

    ReplyDelete
  12. What a great idea! I'm the same way, I have a place for necklaces and earrings but the bracelets are just randomly everywhere. I want to make one of these.
    Loving your blog by the way! I'm following!
    Tiffany
    www.fabulessinheels.com

    ReplyDelete

You are so super sweet for reading and leaving some love!! I absolutely LOVE hearing from you!!! You are the best!

Be sure to make sure you aren't set as a no-comment blogger or leave your email address so I can answer any questions or comments you might have.

You might also enjoy...

Related Posts Plugin for WordPress, Blogger...